Hantek HT301 - Cabo / ponte com conector de sensor

Hantek HT301 - Cabo / ponte com conector de sensor

HANTEK
HT301

Con este cable es fácil tomar lecturas de voltaje de numerosos sensores en el compartimiento del motor del vehículo.

Permite tomar facilmente medidas de sensores, para ello dispone de dos conectores para intercalar en la red, y dos conectores tipo banana de 4 mm que se pueden conectar al osciloscopio utilizando el cable de prueba HT30A.

Apresse-se! Apenas 14 unidades em stock.
28.09 €
34,55 € Incluindo IVA
Quantidade

Entrega em 24h / 48h

HANTEK HT301

Cabo / ponte com conector de sensor

This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment. Connect the breakout lead plugs into the existing wire loom, and insert the two 4mm banana plugs into the oscilloscope using test lead HT30A, the output signal can be taken.

Following sensors can be connected:
Multi-point injection nozzle
Single-point injection nozzle
Induction crankshaft sensor or camshaft sensor
The temperature sensor
Knock sensor
GM ignition coil
Lk hua ignition module
Bosch mechanical injection system - warm-up regulator, subsidiary air valve, temperature timer switch, cold start nozzles.

Lead Length:
Red: 300mm
Yellow: 900mm

HANTEK
HT301
Apresse-se! Apenas 14 unidades em stock.